Updated readme; removed shiftlcd examples

libraries/ShiftLCD/examples/SerialDisplay/SerialDisplay.pde

@@ -1,81 +0,0 @@
-/*
-  ShiftLCD Library - SerialDisplay
- 
- Demonstrates the use a 16x2 LCD display.  The ShiftLCD library works with
- all LCD displays that are compatible with the Hitachi HD44780 driver.
- There are many of them out there, and you can usually tell them by the
- 16-pin interface.
- 
- This sketch displays text sent over the serial port 
- (e.g. from the Serial Monitor) on an attached LCD.
- 
-  The circuit:
- 
- ---Shift Register 74HC595---
- * SR Pin 14 to Arduino pin 2
- * SR Pin 12 to Arduino pin 3
- * SR Pin 11 to Arduino pin 4
- * SR Pin  8 to Ground
- * SR Pin 16 to +5v
- * SR Pin 13 to Ground
- * SR Pin 10 to +5v
- -----Shift Reg to LCD--------
- * SR Pin 15 to D7
- * SR Pin 1  to D6
- * SR Pin 2  to D5
- * SR Pin 3  to D4
- * SR Pin 5  to MOSFET gate
- * SR Pin 6  to Enable
- * SR Pin 7  to RS
- -----LCD HD44780-------------
- * Vss to Ground
- * Vdd to +5V
- * Vo  to 10k Wiper
- * R/W to Ground
- * 5v  to +5v
- * Gnd to MOSFET Drain
- ------N Chanel MOSFET--------
- * Source to Ground
- * Gate   to SP Pin 5
- * Drain  to LCD Gnd
- * 1k Resistor Between gate and source
- 
- For a more detailed schematic, please see my blog:
- 
- http://cjparish.blogspot.com/2010/01/controlling-lcd-display-with-shift.html 
- 
- Library modified from the original LiquidCrystal Library
- This example originaly by Tom Igoe, Jul 2009
- Example modified for use with ShiftLCD
- Chris Parish, January 12th 2010
- 
- */
-
-// include the library code:
-#include <ShiftLCD.h>
-
-// initialize the library with the numbers of the interface pins
-ShiftLCD lcd(2, 4, 3);
-
-void setup(){
-    // set up the LCD's number of rows and columns: 
-  lcd.begin(16, 2);
-  // initialize the serial communications:
-  Serial.begin(9600);
-}
-
-void loop()
-{
-  // when characters arrive over the serial port...
-  if (Serial.available()) {
-    // wait a bit for the entire message to arrive
-    delay(100);
-    // clear the screen
-    lcd.clear();
-    // read all the available characters
-    while (Serial.available() > 0) {
-      // display each character to the LCD
-      lcd.write(Serial.read());
-    }
-  }
-}